797 Air Intake Available for Pre-Order

[Nick79769]

Hey guys & gals! I get phone calls and messages daily on these.

Video of the intake is available on our website.

We have them available for pre-order. I am limiting the pre-order to 16 Pieces for right now, I have 50 tubes in production, The air filters we were only able to obtain 16 of at this time and those are in production as well.

Pre Sale Pricing is $309

What you will receive

797 Performance Intake Pipe
S&B Air Filter
Silicone Coupler & Clamps

Check Out Air Intake Here

Again this is a pre-order, so please do not ask where the order is 2 days later. These are proudly made in the USA and are going to take a little bit of time to produce, after the first round is done we should be fully stocked for a bit for those that do wish to wait.

​

 

[Kingsam19859]

Is it an issue that its in the open like that?

 

[Nick79769]

Is it an issue that its in the open like that?

Compared to the factory air box, we observed intake air temperatures averaging within approximately ±/-5°F with our open-element intake design. The fresh air inlet duct is positioned directly in front of the air filter, helping supply cool outside air while the vehicle is in motion via the duct in the bumper.

It's important to note that any vehicle, regardless of intake design, will experience rising intake air temperatures while sitting stationary due to engine bay heat soak. To provide a fair comparison, we monitored IATs during two separate two-hour drives over the same weekend—one using the factory air box and one using our intake.

Under real-world driving conditions(which is what most of our customer base is), the temperature difference averaged only about ±/-5°F between the two setups.

 

[Zaccity11]

Ordered! Can't wait to get it!

 

[vrax25]

Got super excited unfortunately doesn't ship to Alaska. Big sadge.

 

[aceinspp70]

Got super excited unfortunately doesn't ship to Alaska. Big sadge.

Bummer. Later RJD

 

[Nick79769]

Got super excited unfortunately doesn't ship to Alaska. Big sadge.

We can do that! Just need to quote it out, use the quote request form on the site!

 

[bree198217]

Morning all,

Just received my JB4 from Nick @ 797, thats tomorrows project, l was not gonna bother with CAI, l have been reading more about a restriction in the factor airbox however. Nick does this eliminate the restriction....?

Thanks
Brendan

 

[Nick79769]

Morning all,

Just received my JB4 from Nick @ 797, thats tomorrows project, l was not gonna bother with CAI, l have been reading more about a restriction in the factor airbox however. Nick does this eliminate the restriction....?

Thanks
Brendan

I would say there is more of a restriction in the factory Y(Turbo Inlets). Stuff is coming we all just have to be patient! I think after road kill nights more MFG's will pay more attention to this platform

 

[bree198217]

I would say there is more of a restriction in the factory Y(Turbo Inlets). Stuff is coming we all just have to be patient! I think after road kill nights more MFG's will pay more attention to this platform

Ok, interesting....

I remeber back in the day with Audi, the turbo inlets would suck themselves flat with the increase in boost from a tune, is it something similar...?

Anyways sorry, im very tempted with that CAI lol and its payday hahahaha, nice timing sir, well played hahahaha

 

[vrax25]

We can do that! Just need to quote it out, use the quote request form on the site!

Went ahead and put one in. Thanks Nick.

 

[Nick79769]

Went ahead and put one in. Thanks Nick.

Good to go!

 

[aceinspp70]

Went ahead and put one in. Thanks Nick.

Glade to hear that you can order it. Later RJD