Six Pack Dyno Numbers

[aceinspp72]

Wow, that is the first I've heard of that. Where was this?

Guy here where I live. I thought they had talked about this on your forum. But maybe I am imaging that they mentioned it. Later RJD

 

[cen-tex6]

I borrowed a friend's Racebox and ran some 0-60 and quarter miles today. I want to get a baseline before installing the Cat6. For the 0-60 my best was 4.02 and for the quarter mile 12.14. It's 101 degrees outside right now in Texas. Dodge advertises 3.9 for 0-60 and 12.2 for the quarter. So slightly worse and slightly better. I only used launch control. And these numbers were pretty easy to repeat.

 

[aceinspp72]

Thanks for posting the info on your runs. Later RJD

 

[cen-tex6]

I want to note the SL +/- number at the bottom. I was slightly uphill on the 0-60 and slightly downhill on the quarter. That would explain the small deviation from what Dodge advertises.

 

[El Chorizo33]

Not bad for that kind of heat and not under track conditions. That would be stickier, better 60' for sure.

 

[cen-tex6]

Not bad for that kind of heat and not under track conditions. That would be stickier, better 60' for sure.

I agree. I thought it performed well. These pulls were done on back counter roads. No prepped surface. With the Cat6 I think 11's in the quarter and mid 3's 0-60 are achievable no problem.

 

[El Chorizo33]

I agree. I thought it performed well. These pulls were done on back counter roads. No prepped surface. With the Cat6 I think 11's in the quarter and mid 3's 0-60 are achievable no problem.

On a cold night with a prepped track I think you are right!

 

[cen-tex6]

I let the car sit for a few hours and let the temps drop into the 80's this evening. I was able to rip a 3.91 0-60. The key is getting the brake and gas synced up just right before launching it.